- 1× NeuroNova brain reset chair
- 1× Power Adapter
SETUP INSTRUCTIONS
UNBOX YOUR CHAIR CAREFULLY
- Remove the cord box located in the corner of the shipping box.
- Remove all protective padding.
- Carefully lift the chair out of the box and place it upright on a stable surface.
- Remove the power cord from the cord box.
- Remove the support base foam from the bottom of the box.
- Break down the shipping box and store all packaging materials for future use, if needed.
CONNECT THE POWER CORD.
- Locate the power port on the underside of the chair.
- Hold the threaded connector with the notch facing you.
- Align the connector with the port and push in firmly.
- Twist to tighten until secure. Do not over-tighten.
START A SESSION
- Sit comfortably in the chair with your feet flat on the floor.
- Adjust the chair height if needed using the lever beneath the seat.
- Locate the control panel on the right-hand side of the chair.
- Press the power button to turn the chair on.
- Press the center Play/Pause button to begin your session.
- Press the Play/Pause button again at any time to pause.
Tip: Sit upright during your session to allow the vibration to travel effectively along your spine and to
the base of your skull.
ADJUST INTENSITY
- Use the dial on the control panel to increase or decrease vibration.
- Choose a level that feels comfortable for you. For smaller individuals and youth, we suggest an intensity below the midpoint. Adjust as needed.
- Results are consistent across intensity levels—higher intensity does not improve outcomes.
FOR BEST RESULTS
Use your chair daily for optimal results.